| Q: |
What makes The Ultimate
Card ver.III work exactly in the same way as Pfaff Blank Cards?
|
| A: |
Most Pfaff cards are made by the
same manufacturer as our cards. The same tecnology and
components are used.
|
| Q: |
I've heard
a rumor that using The Ultimate Card may effect my Pfaff/Artista
machine's performance and
void the warranty. Is it true?
|
| A: |
No, it is not. The Ultimate Card ver.III doesn't
have any pre-loaded software on them that can affect any internal
software components or computer programming in your equipment.
Your Pfaff machine will format card for the first time. There
are no mechanical parts that can damage your sewing machine.
Both, The Ultimate Card ver.III and Pfaff/Artista card are
built in compliance with the same PCMCIA standard. Therefore,
to the Pfaff or Bernina Artista machine, there is no difference
whether it's using a Pfaff Blank card, Bernina Artista re-writable
or our card. This has been proven by thousands of satisfied
customers for over 6 years of trouble free use.
|
| Q: |
My Pfaff
machine is connected to the computer via cable. I can not
transfer designs to my Ultimate Card ver.III. Is it a bad
card? |
| A: |
No, it is not. Please, check communications
settings in your software.
|
| Q: |
How long
does the battery last for and can it be replaced in the Ultimate
Card III? |
| A: |
The battery life is approximately
10 years. You can not replace the battery, but you can
replace the card.
|
| Q: |
If
I get the message, "Battery is low," what should I do?
|
| A: |
Leave the card in the
card slot of your machine under power for several hours. The
battery will get charged. If you intend not to use the card
for about 6 months (after the inital use),you should charge
the card battery for about 8 hours. Should you use the card
more frequently, less charging time would be required.
|
| Q: |
How many
designs can I put on The Ultimate Card III? |
| A: |
The number of designs is determined
by the total number of stitches. The card works well with
a total of approximately 300,000 stitches on it. It also depends
on the number of colors.
|
| Q: |
My Ultimate
Card worked great, but suddenly, some designs start "scrambling".
What happened? |
| A: |
There are several reasons that may
cause this problem. One of the reasons could be that the card
is overloaded with designs. Another common reason is poor
digitizing quality. To solve the problem you have to re-format
your card.
|
| Q: |
I've downloaded
only a few designs but I'm told, "The card is full". What
is wrong? |
| A: |
The designs on the card may be too
large. Check the total number of stitches. Sometimes, the
order in which you download your patterns onto the card may
have an effect. In this case, you have to re-format the card
and put designs on it in a different order.
|
| Q: |
How do I
re-format my card ? |
| A: |
Directly in Pfaff machine:
Turn the machine OFF. Insert The Ultimate Card ver.III into
a card slot. While holding the card button down, turn ON the
machine. It should ask you to clear and number the card, do
so. Then, repeat the procedure again.
|
| Q: |
Can I program
my Ultimate Card III for use with Bernina Artista with any
equipment other than Ultimate Box II? |
| A: |
NO.
|
| Q: |
Can I program
my Ultimate card III for use with Pfaff embroidery machine
with any equipment other than Ultimate Box II? |
| A: |
Yes. The Ultimate Card III works
just as the original Pfaff re-writable card (Pfaff creative
card). It can be programmed directly in the Pfaff machine
connected to the computer via Pfaff cable, by Pfaff Creative
station or by Ultimate Box II.
|
|
|
